Overall rating: 5.0 / 5 from 3 reviews.

AI Generated Review Summary

Summary topics

Review topics: [].

Review highlights

Reviews

Q&A

Is there a Kreg clamp that attaches to the side of my adaptive cutting system table that can function as an end vise?

No, there are no clamps made to attach to the side of the ACS Table to be used as a vise.

will this vise mount on kreg adaptive cutting system table

The Vise is not made to attach to the side of the ACS. It is made to attach to the side of a wooden benchtop.

What are the overall dimension of the plate?

That plate measures 8" x 5.5".

Will the Bench Clamp’s non-marring clamp pad work on the Face Clamps?

Due to different head styles, the non-marring pad that comes with your Bench Clamp™ will not work with our Face Clamp™ family. Non-marring pads are usually unnecessary when using our Face Clamps™, as they are generally not used to apply the same amount of clamping pressure as our Bench Clamps™ are.

How do I adjust my Automaxx® Clamps?

Kreg® Clamps with Automaxx® make clamping faster and easier than ever by adjusting automatically to clamp materials that are thick, thin, or in between. With Automaxx, there’s no fussing with knobs that adjust the clamp capacity, no fiddling to get the exact pressure you want, no need for thickness adjustment at all — just powerful, predictable clamping every time. Below are some helpful hints to ensure your clamping experience is consistent every time. Remove the clamp from the packaging and test the clamp pressure on your material. If you are happy with the pressure of the clamp, no further adjustment is needed. If you would like more/less clamping pressure, simply open the clamp handles fully. Once open, turn set screw one-half turn (to the positive for more pressure, to the negative for less pressure) to adjust. Try out the clamp on the same material and repeat these steps until the desired pressure is found. Once you are happy with the clamping pressure, the clamp will maintain this same pressure until you change the setting again. If you would like to increase or decrease clamping pressure, follow the previous steps until the appropriate pressure is met. To ensure consistent pressure, open the clamp handles completely each time you move the clamp. This allows the Kreg Automaxx system to reset for the correct clamping pressure. Following these steps will ensure that these clamps will perform their best for all your project-building needs. If you have any additional questions please contact our Support Team at technicalsupport@kregtool.com.

Can the clamp block be purchased separately so the vise could be in two or locations on a bench.

I m sorry to say, we do not have that block separate. We only have it as a kit.

Is the clamp block extrusion available in longer lengths?

I am sorry to say, we only have the extrusion in the one length.

What are the dimensions of the plate? And distance to and between the countersunk holes?

The plate is 8" wide and 5.5" tall. The mounting holes are 1" from both edges then 6" between the holes.