Overall rating: 4.285714 / 5 from 7 reviews.

AI Generated Review Summary

Summary topics

Review topics: ["quality","clamp"].

Review highlights

Reviews

Truly in love Kreg products!

"Truly in love Kreg products! I have already recommended Kreg tools to others at work! Must have product!"

— Matthew R. (5/5)

I am not exactly sure

"I am not exactly sure what I had in mind of viewing it now I can see that it'll be very helpful to one of the projects I have I'm sure that it'll work out real great as I some other things but not as the type clamping device that Craig tool says I purchased Kreg tools for how much availability I have to that too no luck the straight edge I can use it with the skill saw Saber saw or trim router it's a little workout correctly from expecting there's a different ways."

— Leon G. (5/5)

Love it. I’m adding to

"Love it. I’m adding to to my Christmas wish list."

— Mike M. (5/5)

8" auto adjust bar clamp - nice small clamp

"Nicely done for a clamp that is handy for small projects. While still new, it is a little tight and doesn't move up and down very easy. Find myself using 2 hands to adjust it. By its design, should only take 1."

— Darrell K. (4/5)

Not good quality

"Very useless clamp hard to adjust very poor quality."

— John B. (1/5)

The product work great, great

"The product work great, great quality product"

— Carlos Y. (5/5)

Great

"Great"

— John M. (5/5)

Q&A

How do I adjust my Automaxx® Clamps?: Kreg® Clamps with Automaxx® make clamping faster and easier than ever by adjusting automatically to clamp materials that are thick, thin, or in between. With Automaxx, there’s no fussing with knobs that adjust the clamp capacity, no fiddling to get the exact pressure you want, no need for thickness adjustment at all — just powerful, predictable clamping every time. Below are some helpful hints to ensure your clamping experience is consistent every time. Remove the clamp from the packaging and test the clamp pressure on your material. If you are happy with the pressure of the clamp, no further adjustment is needed. If you would like more/less clamping pressure, simply open the clamp handles fully. Once open, turn set screw one-half turn (to the positive for more pressure, to the negative for less pressure) to adjust. Try out the clamp on the same material and repeat these steps until the desired pressure is found. Once you are happy with the clamping pressure, the clamp will maintain this same pressure until you change the setting again. If you would like to increase or decrease clamping pressure, follow the previous steps until the appropriate pressure is met. To ensure consistent pressure, open the clamp handles completely each time you move the clamp. This allows the Kreg Automaxx system to reset for the correct clamping pressure. Following these steps will ensure that these clamps will perform their best for all your project-building needs. If you have any additional questions please contact our Support Team at technicalsupport@kregtool.com.