How do I adjust the Drill Guide for different material thicknesses?

To ensure the exit-point of your screw is at the center of the workpiece for the strongest joint possible, you’ll need to adjust the position of your pocket hole by raising or lowering the Drill Guide’s height to match your workpiece thickness. Loosen the Drill Guide Pin or pull it back on the Kreg Jig® K5, lift the Drill Guide until the correct mark is showing just above the jig body, and then retighten or release the pin.

This website uses first party and third party cookies to improve your experience and anonymously track site visits. By visiting this website, you opt-in to the use of cookies. OK